Elevations

The commands in this section are used to modify the elevation of standard CAD entities on the drawing.

warning

Do not use these commands to modify the elevation of ducts, diffusers, or mechanical equipment. Use the appropriate query commands instead.

📄️ Move Entity Above Ductwork

The Move Entity Above Ductwork command is used to move an entity on the drawing above the 2D ductwork. The elevation will be set high enough that the entity will be visible when you run the HIDE command. If the elevation of the entity is not set with this command, it may end up below the 2D ductwork and not be displayed.

📄️ Move Entity Below Ductwork

The Move Entity Below Ductwork command is used to move an entity on the drawing below the 2D ductwork. The elevation will be set to 0. When you run the HIDE command, the entity will be hidden by any ductwork drawn over it.

📄️ Move Entity Up

The Move Entity Up command is used to increase the elevation of an entity on the drawing.

📄️ Move Entity Down

The Move Entity Down command is used to decrease the elevation of an entity on the drawing.