Feeders

The Feeders panel appears on the ElectroBIM Single-Line tab when you have a project open in Revit. It includes commands for modifying feeders and graphics that appear on feeders.

Commands

📄️ Circuit Insert

Allows you to insert feeders on the single-line diagram.

📄️ Feeder Auto Draw

Automatically redraws a feeder with its default path and graphics on the single-line diagram.

📄️ Feeder Manual Draw

Allows you to redraw feeders on the single-line diagram.

📄️ Feeder Phase

Allows you to modify the feeder segment family and type for a feeder on the single-line diagram. You can use this command to change the line type for every segment of a feeder.

📄️ Feeder Swap

Allows you to transpose two parallel feeder segments on the single-line diagram.

📄️ Segment Move

Allows you to move feeder segments on the single-line diagram. Any attached feeder segments will update automatically to stay connected.

📄️ Segment Insert

Allows you to add segments to a feeder on the single-line diagram.

📄️ Segment Break

Allows you to insert a break in a feeder segment. You can use this command to add bends to a feeder.

📄️ Segment Offset

Allows you to set the distance between and ordering of parallel feeder segments on the single-line diagram.

📄️ Segment Align

Allows you to align parallel feeder segments on the single-line diagram.

📄️ Segment Trim/Extend

Allows you to reconnect two non-parallel feeder segments that have become disconnected on the single-line diagram, similar to the Revit Trim/Extend to Corner command.