Insert Standard Receptacle
The
To insert a standard receptacle on a drawing, go to
Ribbon: 
Insert Standard Receptacle
Pulldown Menu:
When you run the command, it will attempt to find a receptacle definition in the in the Receptacle Project Schedule with the STANDARD callout. If one does not exist, you will be prompted to create one.
Press the button to open the Receptacle Project Schedule and define a standard receptacle.
Once you have defined the receptacle, press the button to save your changes, then press the button to insert the receptacle on the drawing.
Inserting a Standard Receptacle on the Drawing
You will be prompted to identify where on the drawing the receptacle is to be inserted.
Specify insertion point:
You will then be prompted for the rotation angle. If the receptacle block is not able to be rotated, this prompt will be skipped.
Specify rotation angle <0>:
If there are any notes included with the receptacle, you will then be prompted to insert the notes on the drawing. See the Inserting Notes and Leaders on the Drawing section for more information about inserting the notes.
You will then be prompted to insert another standard receptacle. Continue to insert receptacles, or press ENTER to finish the command.
Receptacles options: Sets the text of the label inserted on the drawing with the receptacle if ☐ Explosion-proof, ☐ Weather-proof, ☐ GFCI, ☐ Ground, or ☐ Isolated Ground is checked.
Insert 3D blocks on drawing: Sets whether a 3D block is inserted on the drawing along with the 2D block.