Edit Transfer Switch List
To edit the transfer switch list project settings, go to
Ribbon:
Pulldown Menu:
To edit transfer switch list master settings, go to
Ribbon:
Pulldown Menu:
Transfer Switch List Label Display and Order Dialog Box
See the Common Label and Schedule Information section for more information about using the and buttons and the Key ☰, Label, Width, Justification ▾, and ☐ Display fields.
Values in the Key ☰ column are listed alphabetically below.
-
Amps This value is taken from the transfer switch definition.
-
Callout The name of the transfer switch.
-
Emergency Feeder Size This value is taken from the transfer switch definition.
-
Emergency Upstream Breaker and Poles The size of the breaker and number of poles for the transfer switch emergency feeder.
Examples: 20/1, 30/3
-
Emergency Upstream Circuit The circuit to which the transfer switch is connected on the upstream device for emergency power.
-
Emergency Upstream Device The upstream device to which the transfer switch is connected for emergency power.
-
Emergency Upstream OCP This value is taken from the transfer switch definition.
-
Fault The total fault in amps at the transfer switch, including the fault from the utility and the fault from any motors in the system.
-
IG Bus This value is taken from the transfer switch definition.
-
List Note 1 This value is taken from the transfer switch definition.
-
List Note 2 This value is taken from the transfer switch definition.
-
List Note 3 This value is taken from the transfer switch definition.
-
Location This value is taken from the transfer switch definition.
-
Lugs This value is taken from the transfer switch definition.
-
Mounting This value is taken from the transfer switch definition.
-
NEMA This value is taken from the transfer switch definition.
-
Neutral This value is taken from the transfer switch definition.
-
Normal Feeder Size This value is taken from the transfer switch definition.
-
Normal Upstream Breaker and Poles The size of the breaker and number of poles for the transfer switch normal feeder.
Examples: 20/1, 30/3
-
Normal Upstream Circuit The circuit to which the transfer switch is connected on the upstream device for normal power.
-
Normal Upstream Device The upstream device to which the transfer switch is connected for normal power.
-
Normal Upstream OCP This value is taken from the transfer switch definition.
-
Note 1 This value is taken from the transfer switch definition.
-
Note 2 This value is taken from the transfer switch definition.
-
Number of Taps This value is taken from the transfer switch definition.
-
Short Voltage The voltage value and poles of the transfer switch.
Examples: 208Y/120V 1P, 208V 2P
-
Total Calculated Amps The total calculated load in amps of the transfer switch.
-
Total Calculated KVA The total calculated load in kVA of the transfer switch.
-
Total Connected Amps The total calculated load in amps of the transfer switch.
-
Total Connected KVA The total calculated load in kVA of the transfer switch.
-
Type This value is taken from the transfer switch definition.
-
Utility Fault The utility fault in amps at the transfer switch.
tipUse this column instead of the Fault column if you do not want to include motor contributions.
-
Volts The full voltage value of the transfer switch. The volts, poles, and wires will be displayed.
Examples: 208Y/120V 1P 2W, 208V 2P 2W
-
Volts Only The voltage value of the transfer switch. Only the volts will be displayed. The poles and wires will not be displayed.
Examples: 208Y/120V, 208V