Create Plan View Block from This Drawing
The
This command will not create a slide for the block. You can manually create a slide for the block using the Create Slide command.
To configure the current drawing as a plan view block, go to
Ribbon:
Pulldown Menu:
You will be prompted to specify the insertion point for the block.
Specify insertion base point:
The Design Master Electrical dialog box shown below will appear.
Press the button to connect loops to the edges of a circle on this block. Press the button to connect loops to the edges of a rectangle on this block. Press the button to connect loops to points on this block.
Connecting Loops to the Edge of a Circle​
If the button is pressed, you will be prompted to specify a point on one side of the circle.
Specify a point on one side of circle:
You will then be prompted to identify a point on the opposite side of the circle.
Specify a point on opposite side of circle:
Connecting Loops to the Edge of a Rectangle​
If the button is pressed, you will be prompted to identify the location of the first corner of the rectangle.
Specify first corner of rectangle:
You will then be prompted to identify the location of the opposite corner.
Specify opposite corner of rectangle:
Connecting Loops to Points on the Device​
If the button is pressed, you will be prompted to identify the location where the loop is to connect to the device.
Specify connection point:
Specify as many connection points as desired for the block. Press ENTER to finish the command.